APM2.9 Flight Controller
Note:Now the latest Mission planner 1.3.76 has bug ,it can not calibrate Accel for APM,Waiting for the official fix of this bug, please use version 1.3.74.
APM2.9 is used in the same way as APM2.6, 2.8. The benefit is that APM 2.9 supports PPM or PWM receiver protocols.
Why use the PPM protocol? The communication speed is fast, the wiring is simple, only one needed, unlike each channel of the PWM, the PWM communication speed is slower than PPM/SBUS.
The product supports the PPM receiver protocol and supports the PWM protocol. Before using this product, make sure your receiver is PPM-enabled. If your receiver does not support PPM, use the PWM protocol.
Also, you can upload firmware from Mission Planner.Uploading firmware does not affect support for PPM.
When connect INPUT 2 and 3(Insert Jumper),use PPM.
when Disconnect INPUT 2 and 3(Remove Jumper) ,use PWM
NOTE:The hardware of APM2.9 is same as APM2.8. Apm2.9 uses the PCB hardware of apm2.8. It\'s just that the code of the 32u2 chip is different.The 32u2 chip of apm2.9 supports PPM and PWM functions.
PackageD included:
1x APM2.9 flight controller board with shell(without Built-in compass )
1x M8N GPS Moudule with shell(with external compass)
1x Shock absorber
1x GPS stand
1x RC receiver cable
1x Radio Telemetry(100mw.433MHZ,if need 915 MHZ, leave a message)
1x PWMRC Receiver Connection /span>
1x PPMRC Receiver Connection /span>
Radio telemetry V1
M8N GPS:
Power Module:
For PIXHAWK 2.4.8 :used for PIXHAWK2.4.8 AND APM2.8 Flight Control
For PIXHAWK PRO :used for PIXHAWK PRO Flight Control
For PIXHAWK 6C :used for PIXHAWK 6C Flight Control
Description:
This Power Module PRO provides a simple way to supply regulated 5.2V to flight controller from the battery while providing current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable. It comes with pre-soldered wires, capacitor, and XT60 connector on both ends, along with shrink tubing on the PCBA for physical protection.
Specification:
Input Voltage: 2S-12S
PCB Cont. Current Rating: 60A
PCB Burst Current Rating: 100A (<60 Sec)
Max Current Sensing: 120A
Output: DC 5.2V & 3A Max
Voltage Divider: 18.182
Amperes per Volt: 36.364
Weight: 20g
Please Note:
- The XT60 Plug and 12AWG wire that are pre-soldered on the board is rating for 30A continuous current and 60A burst current (< 60 Seconds). If a higher current is being used, the plug type and wire size should be changed accordingly. You can refer to this chart for reference.
商品備註・物品狀況:全新・最新關注時間:2026-10-15